Weidmuller PMX400HZX - Display instrument for control panel Uživatelský manuál stáhnout pdf (Strana 21)

Analogue outputs*

Analogue output

select

AOPY

AOPN

Enabled

Disabled (Select this option for PMX420)

Toggle Accept

Output action

OP=d

OP=r

Direct

Reversed

Toggle Accept

Analogue output

range

OPL=

4.00

Output low value

e.g., 4.00

Dec

Inc

OPH=

20.00

Output high value

e.g., 20.00

Dec

Inc

Note: to change the output high or low value you must calibrate the outputs.

eneral Alarm settings*

Alarms 1 & 2

Select

A12Y

A12n

Enable

Disable

Toggle Accept

Alarms 3 & 4

Select

A34Y

A34n

Enable

Disable

Toggle Accept

Setpoint security

SECy

SECn

Setpoints ﬁxed at setup

Can change setpoints

Toggle Accept

Alarm reset

sequence

nOr

rES

Automatic reset

Manual reset

Toggle Accept

Note: alarm settings are only shown if the relevant alarm channel is enabled.

larm channel one settings*

Coil energisation

A1nE

A1nd

Normally energised

Normally de-energised

Toggle Accept

Alarm type

A1=L

A1=H

Low type (active below setpoint)

High type (active above setpoint)

Toggle Accept

Setpoint value

SP1=

50.00

Setpoint value

e.g., 50.00 %

Dec

Inc

Deadband value

db1=

0.01

Deadband value

e.g., 0.01 %

Dec

Inc

Timer delay

dL1=

Timer delay (set to 0s to disable)

e.g., 20 s

Dec

Inc

Alarm channel two settings*

As alarm channel one, except uses A2nE, A2nd, A2=L,A2=H, SP2=, db2= and dL2=.

larm channel three settings*

As alarm channel one, except uses A3nE, A3nd, A3=L,A3=H, SP3=, db3= and dL3=.

Setup Sequence (continued)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Komentáře k této Příručce

Žádné komentáře

Weidmuller PMX400HZX - Display instrument for control panel Uživatelský manuál Strana 21

Komentáře k této Příručce

Související produkty a manuály pro Hardware Weidmuller PMX400HZX - Display instrument for control panel