Weidmuller UHZAR - Universal glavanically isolated signal con Uživatelský manuál Strana 21

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 24
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 20
21
Power Supply Requirements
Check the power supply against the model number before applying
power to the instrument. Micromann modules must be used with a
suitable mains Power Supply, ratings are as follows:
Voltage Range Nominal Voltage Power Frequency
100–132 V AC 110 V AC 6 VA 47-63 Hz
200264 V AC 240 V AC 6 VA 47-63 Hz
12–50 V DC* 24 V DC 6 W (at 24 V DC) -
*Using a DC power supply that provides this voltage will comply with
the instrument’s UL/CSA listing.
• Calibration
General
The UHZ/AR is factory calibrated and will operate with any input or
output format without recalibration.
During calibration allow a few seconds for signals to stabilise before
accepting the value.
7
Link to change the set-up Security Link
8
9 Neutral (−)
Power supply
10 Live (+)
11 Channel one
Alarm outputs
12 Channel two
13 Common
14 Output +
Analogue outputs15 Current −
16 Voltage −
Case Earthing is via a stud on lower side of case
Connections (continued)
Zobrazit stránku 20
1 2 ... 16 17 18 19 20 21 22 23 24

Komentáře k této Příručce

Žádné komentáře