Weidmuller PTX800A - Configurable counter and totalizer Uživatelský manuál stáhnout pdf (Strana 42)

Procedure

When the

display shows

Action/Description

Put the instrument in setup mode and scroll through the main menu

CALIn_n

Press ì or Å

CAlIn_y

Press PGM to select Input calibration

InP_LO_=

Connect the multimeter to measure the Input level, then press PGM

4.00

Set the Input signal to the appropriate value, e.g., 4.00 mA

When you are happy that the Input is correct, press PGM

Inp_HI_=

After approx 5s the display introduces the next calibration point. Press PGM

20.00

Set the Input signal to the appropriate value, e.g., 20.00 mA

When you are happy that the Input is correct, press PGM

dFactor=

Continue with the setup sequence.

Note: Do not remove the power while the save message is on display.

PTX800 analogue output board showing output type jumper locations.

Link both pairs

of posts for

voltage outputs

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48

Žádné komentáře

Weidmuller PTX800A - Configurable counter and totalizer Uživatelský manuál Strana 42