Weidmuller WI-MOD-E-G Uživatelský manuál stáhnout pdf (Strana 25)

Chapter Three Operation

Page 25 March 2010

3.3.2 Set WI-MOD-9-E to same network as PC

This is the alternate procedure to setting an IP address in the WI-MOD-9-E. Consult your

network administrator for an IP address on your network, the gateway IP address, and network

mask.

a) Switch Factory Default dip-switch on WI-MOD-9-E to SETUP position.

b) Connect the RS232 port on the WI-MOD-9-E to the RS232 port on the PC using a “straight-

through” serial cable.

c) Open a terminal package (such as Hyperterminal) with 19200bps data rate, 8 data bit, 1 stop,

no parity and no flow control. Make sure that no other programs have control of the serial

port.

d) Power up WI-MOD-9-E. Basic network settings will be displayed on the terminal as

illustrated below. When prompted, hit enter key to stop automatic boot process. You have 5

seconds to abort the boot process.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 81 82

Žádné komentáře

Weidmuller WI-MOD-E-G Uživatelský manuál Strana 25