Weidmuller WI-I/O 9-L: Wireless I/O Transmitter / Receiver v1 Uživatelský manuál stáhnout pdf (Strana 14)

WI-I/O 9-L Configuration Manual

WI-I/O 9-L Wireless I/O page 14 of 108



This section describes how to configure your WI-I/O 9-L.

Note

For more information on installing your WI-I/O 9-L, please see the WI-I/O 9-L Installation

Guide.

You can configure your network using:

 User-defined (customized) configuration – that lets you set specific information

about your network and allows communication with other Weidmuller, Inc. I/O modules.

 Default factory configuration – that lets you use a transmitter and receiver as a

simple send/receive pair.

This manual describes how to perform custom configuration to:

 Fully utilize of the features of the WI-I/O 9-L modules; and

 Communicate between WI-I/O 9-L modules and other Weidmuller, Inc. I/O modules.

For more information on restoring the default configuration (i.e. linking), refer to the Quick

Start Guide included with your module.

The following tables detail the default settings:

Setting Default

Periodic transmission

Every second

Analog sample rate

5 samples per second

Analog change of state sensitivity

Output state on comms failure

Reset to zero

Analog setpoints

Set by rotary switch (switch value x 10%±5%)

Analog Input debounce

1 sample

Digital input debounce time

0.5 seconds

Signals sent over radio

WI-I/O 9-L-T(Transmitter) Sends WI-I/O 9-L-R (Receiver)

Digital Input 1



Digital Output 1

Digital Input 2



Digital Output 2

Analog Setpoint



Digital Output 3

Analog input (4-20 mA)



Analog output

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 107 108

Komentáře k této Příručce

Žádné komentáře

Weidmuller WI-I/O 9-L: Wireless I/O Transmitter / Receiver v1 Uživatelský manuál Strana 14

Komentáře k této Příručce

Související produkty a manuály pro Hardware Weidmuller WI-I/O 9-L: Wireless I/O Transmitter / Receiver v1