Weidmuller AMS400A - Universal interface device Uživatelský manuál stáhnout pdf (Strana 41)

• Output type Selection and Calibration

Analogue Output Setup

The analogue output type can be set by the position of two push-fit

jumpers on J1 and J2 of the analogue output board. The analogue

output board runs along the center of the main PCB and at right angles

to it.

• For Voltage outputs, connect the jumpers across J1 and J2.

• For current outputs, ﬁt the jumpers to one post only.

nalogue Output Calibration

Equipment requirements

• An accurate digital multimeter (accurate to 0.05 mV and ±0.1 μA)

Terminal Connections for output calibration

Calibration Stage Signal type Terminal

Analogue Output

Current/Voltage output + 3

Current/Voltage output − 4

1 2 ... 36 37 38 39 40 41 42 43 44

Žádné komentáře

Weidmuller AMS400A - Universal interface device Uživatelský manuál Strana 41